Table of Contents
Advertisement
Transmit Rate (Mpbs)........................... 1 Mbps
Beacon Period (msecs).......................... 100
Discovered Age................................. 0d:00:03:01
Age............................................ 0d:00:02:57
Security Mode.................................. Open
Highest Supported Rate (per 100Kbps)........... 10
802.11n Mode................................... Supported
Ad hoc Network................................. Not Ad hoc
Rogue Mitigation............................... Not Required
(DWS-4026) #
show wireless ap rf-scan triangulation
This command displays the signal triangulation status for the specified RF scan entry. Triangulation information is provided
to help locate the rogue AP by showing which managed APs detect each device discovered through the RF Scan. Up to six
triangulation entries are reported for each AP detected through the RF Scan: three entries by non-sentry APs and three
entries by sentry APs. Since an AP may have one radio configured in sentry mode and another radio configured in non-
sentry mode, the same AP can appear in both lists. If the AP has not been detected by three APs, then the list may contain
zero, one, or two entries.
Format
show wireless ap <macaddr> rf-scan triangulation
Mode
Privileged EXEC
Field
Description
macaddr
AP MAC address detected in RF scan.
Sentry
Identifies whether the AP that detected the entry is in sentry or non-sentry mode.
MAC Address
Shows the MAC address of the AP that detected the RF Scan entry. The address links to the valid AP
database.
Radio
Identifies the radio on the AP that deleted the RF Scan entry.
RSSI
Shows the received signal strength indicator (RSSI) in terms of percentage for the non-sentry AP. The
range is 0, which means the AP is not detected, to 100%.
Signal (dBm)
Received signal strength for the non-sentry AP. The range is -127 dBm to 127 dBm, but most values
are expected to be range from -95 dBm to -10 dBm.
Noise (dBm)
Noise reported on the channel by the non-sentry AP.
Age
Time since this AP was last detected in an RF scan.
Example: The following shows example CLI display output for the command.
(DWS-4026) #show wireless ap 00:02:BC:00:17:D0 rf-scan triangulation
Sentry
MAC Address
---------- ----------------- ----- ---- ------ ----- -----------
Non-Sentry 00:22:B0:3A:C1:80
show wireless ap rf-scan rogue-classification
This command displays the WIDS AP rogue classification test results.
RSSI Signal Noise
Radio (%)
(dBm)
(dBm) Age
2
15
-80
RF Scan Access Point Status Commands
-92 0d:15:48:19
309
Advertisement
Table of Contents
