D-Link DWS-4000 Series Cli Command Reference page 386

D-Link Unified Switch CLI Command Reference
no traffic-shape
This command restores the interface shaping rate to the default value.
Format
no traffic-shape
Modes • Global Config
• Interface Config
show classofservice dot1p-mapping
This command displays the current Dot1p (802.1p) priority mapping to internal traffic classes for a specific interface. The
<slot/port> parameter is optional. If specified, the 802.1p mapping table of the interface is displayed. If omitted, the most
recent global configuration settings are displayed. For more information, see
Format
show classofservice dot1p-mapping [<slot/port>]
Mode Privileged EXEC
The following information is repeated for each user priority.
Definition
Term
User Priority The 802.1p user priority value.
Traffic Class The traffic class internal queue identifier to which the user priority value is mapped.
Example: The following shows example CLI display output for the command.
(DWS-4026) #show classofservice dot1p-mapping
User Priority
-------------
0
1
2
3
4
5
6
7
The following information is repeated for each user priority.
Term Definition
IP Precedence The IP Precedence value.
Traffic Class The traffic class internal queue identifier to which the IP Precedence value is mapped.
© 2009 D-Link Corporation. All Rights Reserved
378
Traffic Class
-------------
1
0
0
1
2
2
7
3
"Voice VLAN Commands" on page 45
.