Table of Contents
Advertisement
D-Link Unified Switch CLI Command Reference
no set igmp querier
Use this command to disable IGMP Snooping Querier on the system. Use the optional address parameter to reset the
querier address to 0.0.0.0.
Format
no set igmp querier [<vlan-id>] [address]
Mode
• Global Config
• VLAN Mode
set igmp querier query-interval
Use this command to set the IGMP Querier Query Interval time. It is the amount of time in seconds that the switch waits
before sending another general query.
Default
disabled
Format
set igmp querier query-interval <1-18000>
Mode
Global Config
no set igmp querier query-interval
Use this command to set the IGMP Querier Query Interval time to its default value.
Format
no set igmp querier query-interval
Mode
Global Config
set igmp querier timer expiry
Use this command to set the IGMP Querier timer expiration period. It is the time period that the switch remains in Non-
Querier mode once it has discovered that there is a Multicast Querier in the network.
Default
60 seconds
Format
set igmp querier timer expiry <60-300>
Mode
Global Config
no set igmp querier timer expiry
Use this command to set the IGMP Querier timer expiration period to its default value.
Format
no set igmp querier timer expiry
Mode
Global Config
set igmp querier version
Use this command to set the IGMP version of the query that the snooping switch is going to send periodically.
Default
1
Format
set igmp querier version <1-2>
Mode
Global Config
© 2009 D-Link Corporation. All Rights Reserved
126
Advertisement
Table of Contents
