D-Link DWS-4000 Series Cli Command Reference page 246

Hide thumbs Also See for DWS-4000 Series:

Table of Contents

D-Link Unified Switch CLI Command Reference

location <value>

This parameter is an AP location string. It should not be more than 32 characters long. To use spaces

in the location, enclose the value with quotes, for example "Conference Room A".

The no version of this command deletes the current location string for the AP.

password (AP Config Mode)

This command configures the password that this AP must use to authenticate to the Unified Switch. The password is only

verified if global AP authentication is enabled. After you enter the password, the CLI prompts you to enter a password that

is between 8-63 alphanumeric characters.

The default password is blank.

The no version of this command deletes the password for the AP.

Example: The following shows an example of the command.

DWS-4026 (Config-ap)# password ?

<cr>Press Enter to execute the command.

DWS-4026 (Config-ap)# password <cr>

Enter Password (8 - 63 characters):<enter here>

Re-enter password:<enter same here>

DWS-4026 (Config-ap)# no password <cr>

DWS-4026 (Config-ap)#

password encrypted

This command configures the password that this AP must use to authenticate to the Unified Switch. The password is only

verified if global AP authentication is enabled. The command accepts the AP password in an encrypted format.