D-Link DWS-4000 Series Cli Command Reference page 96

D-Link Unified Switch CLI Command Reference
Note: This command is only applicable to physical interfaces.
no lacp partner system priority
Use this command to configure the default administrative value of priority associated with the Partner's System ID.
Format
no lacp partner system priority
Mode Interface Config
port-channel static
This command enables the static mode on a port-channel (LAG) interface. By default the static mode for a new port-channel
is disabled, which means the port-channel is dynamic. However if the maximum number of allowable dynamic port-channels
are already present in the system, the static mode for a new port-channel enabled, which means the port-channel is
static.You can only use this command on port-channel interfaces.
Default disabled
Format
port-channel static
Mode Interface Config
no port-channel static
This command sets the static mode on a particular port-channel (LAG) interface to the default value. This command will be
executed only for interfaces of type port-channel (LAG).
Format
no port-channel static
Mode Interface Config
port lacpmode
This command enables Link Aggregation Control Protocol (LACP) on a port.
Default enabled
Format
port lacpmode
Mode Interface Config
no port lacpmode
This command disables Link Aggregation Control Protocol (LACP) on a port.
Format
no port lacpmode
Mode Interface Config
© 2009 D-Link Corporation. All Rights Reserved
88