Hitachi CHROMASTER 5160 Instruction Manual page 535

(xi) The spectrum output screen appears, and
<Spectrum output screen>
RCD NO.
1
(xii) When the spectrum output is completed, the 1
NOTE:
NOTE:
(3) Determination of Raman Signal Intensity
S
(baseline method)
Fig. 4-2 Measuring the Raman Signal Intensity
Determine the voltage value corresponding to S in the
figure. When using the D-2500 chromato-data processor,
calculation can be made using the length (L in mm) of S on
the chart.
S =
162
L:
x:
spectrum output begins.
Ex Em
350 350 1000.0
monitor screen returns automatically.
Set the following conditions for the D-2500
chromato-data processor.
ATT
CHART SPEED : 60 mm/min
If the detector and data processor are
connected via E-Line (digital), start the
output by pressing the
data processor.
Tangent
L
x
× 2
mV
Length of S (mm)
ATT setting of data processor used in
measurement
4 - 9
FL SPEED
60
: 5
ALL
START
S (tangent method)
MODE
Em
st
key of the
Baseline