Hitachi CHROMASTER 5160 Instruction Manual page 300

3.2 Utility Setting
(d) Setting the ON/OFF Status of D
SET UP
UTLTY
1) Press
2) The utility setup screen appears.
Utility Setup Screen
UTILITY (OFFSET=1, TIME CONSTANT=2,
1 USE PROG=3, POLARITY=4, OTHERS=5)
Select OTHERS.
Press [numerical] key [5], and then the [ENT] key.
3) The OTHERS setup screen appears.
OTHERS (PROCESSOR=1, ERROR OUT=2
1 LEAK SENSOR=3, LAMP=4, GAIN=5)
Select LAMP.
Press [numerical] key [3], and then the [ENT] key.
4) The LAMP setup screen appears.
LAMP ON/OFF (OFF=0, D2=1, W=2, D2&W=3)
1
Set the ON or OFF status of each lamp.
Press [numerical] key (within [0] to [3]), and then the
[ENT] key.
* Default value: 3
For selection of D2 lamp : Press [numerical] key [1],
For selection of W lamp : Press [numerical] key [2],
For selection of D2 and
W lamps
For selection of lamp
OFF status
3 - 18
Lamp/W Lamp
2
key.
and then the [ENT] key.
and then the [ENT] key.
: Press [numerical] key [3],
and then the [ENT] key.
: Press [numerical] key [0],
and then the [ENT] key.