Hitachi CHROMASTER 5160 Instruction Manual page 298

3.2 Utility Setting
Set the full scale of processor output.
Press [numerical] key (within [1] to [4]), and then the
[ENT] key.
* Default value: 3
5) Upon completion of processor setting, the first monitor
screen reappears.
(b) Setting the Enable or Disable Status of Error Signal Output
SET UP
UTLTY
1) Press
2) The utility setup screen appears.
Utility Setup Screen
UTILITY (OFFSET=1, TIME CONSTANT=2,
1 USE PROG=3, POLARITY=4, OTHERS=5)
Select OTHERS.
Press [numerical] key [5], and then the [ENT] key.
3) The OTHERS setup screen appears.
OTHERS (PROCESSOR=1, ERROR OUT=2
1 LEAK SENSOR=3, LAMP=4, GAIN=5)
Select ERROR OUT.
Press [numerical] key [2], and then the [ENT] key.
4) The ERROR OUT setup screen appears.
ERROR OUT SIGNAL (DISABLE=0，ENABLE=1)
1
Set the ENABLE or DISABLE status of ERROR OUT.
Press [numerical] key ([1] or [0]), and then the [ENT]
key.
* Default value: 1
5) Upon completion of ERROR OUT setting, the first
monitor screen reappears.
3 - 16
key.