Rear Panel - Hitachi CHROMASTER 5160 Instruction Manual

2.3 Rear Panel

2.3 Rear Panel
No. Indication
1 e-Line
2 LAMP OFF IN
3 AUTO ZERO IN
4 PROCESSOR
(option)
5 RECORDER
(option)
6 MARKER IN
(option)
MARKER IN
PROCESSOR RECORDER
4 5
6
Fig. 2-3 Rear Panel
Function
(1) Used to transmit the
acquisition signal (or acquired
spectral data) via the e-Line.
Also, used to send/receive the
instrument condition data via
the e-Line.
(2) Used for input/output of each
contact signal.
(a) START IN
(b) ERROR IN
(c) ERROR OUT
(d) BUSY OUT
The light source lamp is turned off
in response to contact signal input.
Auto-zero operation is executed in
response to contact signal input.
Analog output for data processor
(integrator)
(1) Absorbance value at each time
point
(2) Stored spectral data
Analog output for recorder
(1) Absorbance value at each time
point
(2) Stored spectral data
The marker function is started in
response to contact signal input.
2 - 4
2 3
Remarks
(1) Absorbance values are
output.
(2)- (a) Program start
(b) Recognition of error
in other instrument
(c) Indication of error
condition
(d) Indication of
operating status
Absorbance value is output.
Absorbance value is output.
This function is started
when the short-circuit
signal lasts 1 sec or longer.