Hitachi CHROMASTER 5160 Instruction Manual page 442

Analog signal output
unit (option)
Power source
connector
No. Indication
1 e-line
2 LAMP OFF IN
3 AUTO ZERO IN
Ground terminal
Fig. 2-2
Analog signal output unit (Option)
:Provides PROCESSOR, RECORDER, MAKER IN terminal.
Ground terminal
:The terminals for grounding connection (three terminals).
Power source connector
:Connects the power supply cable.
Table 2-2
Function
1. Used to transmit the acquired
signal (or the acquired spectral
data) to other units on the e-line.
Also, used to send/receive the
instrument parameter data via the
e-line.
2. Used for input/output of each
contact signal.
• START IN
• ERROR IN
• ERROR OUT
• BUSY OUT
The lamp is turned off by means of a
contact signal input.
The auto zero function is activated by
means of contact signal input.
LAMP OFF IN
AUTO ZERO IN
Rear Panel
Input/Output terminal
1. The florescence intensity data
2.
2 - 2
Remarks
is output.
• The program is initiated.
• An error condition in
another instrument is
checked.
• An error condition on this
instrument is indicated.
• The operational status of
the instrument is indicated.
e-Line