Table of Contents
Advertisement
3 Maintenance
3.3.3. Inspection, oil level gearbox axis 3
Continued
Inspection, oil level gearbox 3
The procedure below details how to inspect the oil level in the gearbox axis 3.
120
Action
1.
WARNING!
Handling gearbox oil involves several safety
risks. Before proceeding, please observe the
safety information in section
risks during work with gearbox oil on page
2. Move the robot to the calibration position.
3.
DANGER!
Turn off all electric power, hydraulic and
pneumatic pressure supplies to the robot!
For Foundry Prime robots: Do not turn off the air
pressure to motors and SMB.
4. Open the oil plug, filling.
5. Required oil level: max. 5 mm below the oil plug
hole.
6. Add oil if required.
7. Refit the oil plug, filling.
Note
WARNING - Safety
36.
Detailed in section
and correct axis position on page
376.
Shown in the figure
gearbox on page
Art. no. is specified in
equipment on page
Further information about how to fill
the oil may be found in section
oil on page
Tightening torque: 24 Nm.
Calibration scales
Location of
119.
Required
119.
Filling,
161.
3HAC026876-001 Revision: C
Advertisement
Table of Contents
