Epson S1D13706 Technical Manual page 268

Page 8
S1D13706
X31B-B-001-03
Register Address
Display Buffer Address
Note
When "Epson S5U13706B00B/B00C Evaluation Board" is selected, the register and
display buffer addresses are blanked because the evaluation board uses the PCI interface
and the decode addresses are determined by the system BIOS during boot-up.
If using the S1D13706 Evaluation Board on a PCI based platform, both Windows and
the S1D13XXX device driver must be installed. For further information on the
S1D13xxx device driver, see the S1D13XXX 32-bit Windows Device Driver Installation
Guide, document number X00A-E-003-xx.
The physical address of the start of register decode
space (in hexadecimal).
This field is automatically set according to the Decode
Address unless the "User-Defined" decode address is
selected.
The physical address of the start of display buffer
decode space (in hexadecimal).
This field is automatically set according to the Decode
Address unless the "User-Defined" decode address is
selected.
Epson Research and Development
Vancouver Design Center
13706CFG Configuration Program
Issue Date: 01/03/29