Redcap2 To S1D13706 Interface; Hardware Description - Epson S1D13706 Technical Manual

Embedded memory lcd controller

Hide thumbs Also See for S1D13706:

Table of Contents

4 REDCAP2 to S1D13706 Interface

*Note: This example uses CS1. CSn can be any of CS0-CS4.

When connecting the S1D13706 RESET# pin, the system designer should be aware of all

conditions that may reset the S1D13706 (e.g. CPU reset can be asserted during wake-up

from power-down modes, or during debug states).

Figure 4-1: Typical Implementation of REDCAP2 to S1D13706 Interface

X31B-G-014-02

The interface between the S1D13706 and the REDCAP2 requires no external glue logic.

The information in this section describes the environment necessary to connect the

S5U13706B00C Evaluation Board and the Motorola DSP56654 Application Development

Module (ADM). For a list of connections between the pins and signals of the REDCAP2

and the S1D13706 see Table 4-1:,"List of Connections from REDCAP2 ADM to

S5U13706B00C" on page 13.

The following figure demonstrates a typical implementation of the S1D13706 to

REDCAP2 interface.

Interfacing to the Motorola RedCap2 DSP With Integrated MCU

Epson Research and Development

Vancouver Design Center

Issue Date: 01/02/23

Table of Contents