Table 8-14: 32-Bit Address Increments For Color Depth - Epson S1D13706 Technical Manual

Epson Research and Development
Vancouver Design Center
+
PIP Window Y End Position Register 0
REG[90h]
7 6
+
PIP Window Y End Position Register 1
REG[91h]
7 6
bits 9-0
Note
Hardware Functional Specification
Issue Date: 01/11/13
+
PIP Window Y End Position Bits 7-0
5
n/a
5
+
PIP Window Y End Position Bits [9:0]
These bits determine the Y end position of the PIP
panel. Due to the S1D13706 SwivelView feature, the Y end position may not be a vertical
position value (only true in 0° and 180° SwivelView). For further information on defining
the value of the Y End Position register, see Section 13, "Picture-in-Picture Plus (PIP+)"
on page 143.
The register is also incremented differently based on the SwivelView orientation. For 0°
and 180° SwivelView the Y end position is incremented in 1 line increments. For 90° and
270° SwivelView the Y end position is incremented by y pixels where y is relative to the
current color depth.

Table 8-14: 32-bit Address Increments for Color Depth

Depending on the color depth, some of the higher bits in this register are unused because
the maximum vertical display height is 1024 pixels.
1
These bits have no effect unless the PIP
(REG[71h] bit 4).
2
The effect of REG[84h] through REG[91h] takes place only after REG[91h] is written
and at the next vertical non-display period.
4 3
4 3
Color Depth Pixel Increment (y)
1 bpp
2 bpp
4 bpp
8 bpp
16 bpp
+
Window Enable bit is set to 1
2 1
+
PIP Window Y End Position
Bits 9-8
2 1
+
window in relation to the origin of the
32
16
8
4
2
Page 119
Read/Write
0
Read/Write
0
S1D13706
X31B-A-001-08