Table of Contents
Advertisement
Page 8
S1D13706
X31B-B-003-02
RW addr [count]
Reads a certain number of words from the specified address. If no value is provided for
count, it defaults to 10h.
Where:
addr
count
T xx
Tests VNDP read for xx seconds. (This option was developed for testing purposes only
and is not supported.)
Where:
xx
V
Calculates the current frame rate from the VNDP count.
W addr data ...
Writes byte(s) of data to specified memory address.
Where:
addr
data
WD addr data ...
Writes dword(s) of data to specified memory address.
Where:
addr
data
WW addr data ...
Writes word(s) of data to specified memory address.
Where:
addr
data
Address from which word(s) are read (hex).
Number of words to be read (hex).
The number of seconds VNDP is tested (decimal).
Address data is written to.
Data to be written (hex). Data can be a list of bytes to be
repeated for the duration of the write. To use decimal
values, attach a "t" suffix to the value (e.g. 100t is 100
decimal). To use binary values attach a "'b" suffix to the
value (e.g. 0111'b).
Address data is written to
Data to be written (hex). Data can be a list of dwords to be
repeated for the duration of the write. To use decimal
values, attach a "t" suffix to the value (e.g. 100t is 100
decimal). To use binary values attach a "'b" suffix to the
value (e.g. 0111'b).
Address data is written to
Data to be written (hex). Data can be a list of words to be
repeated for the duration of the write. To use decimal
values, attach a "t" suffix to the value (e.g. 100t is 100
decimal). To use binary values attach a "'b" suffix to the
value (e.g. 0111'b).
Epson Research and Development
Vancouver Design Center
13706PLAY Diagnostic Utility
Issue Date: 01/02/23
Advertisement
Chapters
Table of Contents
