Table of Contents
Advertisement
Page 6
S1D13706
X31B-B-003-02
F addr1 addr2 data...
Fills a specified address range with 8-bit data (bytes).
Where:
addr1
addr2
data
FD addr1 addr2 data...
Fills a specified address range with 32-bit data (dwords).
Where:
addr1
addr2
data
FW addr1 addr2 data...
Fills a specified address range with 16-bit data (words).
Where:
addr1
addr2
data
H [lines]
Sets the number of lines of data that are displayed at a time. The display is halted after the
specified number of lines. Setting the number of lines to 0 disables the halt function and
allows the data to continue displaying until all data has been shown.
Where:
lines
I
Initializes the S1D13706 registers with the default register settings as configured by the
utility 13706CFG. To initialize the S1D13706 with different register values, reconfigure
13706PLAY using 13706CFG. For further information on 13706CFG, see the 13706PLAY
User Manual, document number X31B-B-001-xx.
Start address of the range to be filled (hex).
End address of the range to be filled (hex).
Data to be written (hex). Data can be a list of bytes to be
repeated for the duration of the fill. To use decimal values,
attach a "t" suffix to the value. (e.g. 100t is 100 decimal)
Start address of the range to be filled (hex).
End address of the range to be filled (hex).
Data to be written (hex). Data can be a list of dwords to be
repeated for the duration of the fill. To use decimal values,
attach a "t" suffix to the value. (e.g. 100t is 100 decimal)
Start address of the range to be filled (hex).
End address of the range to be filled (hex).
Data to be written (hex). Data can be a list of words to be
repeated for the duration of the fill. To use decimal values,
attach a "t" suffix to the value. (e.g. 100t is 100 decimal).
Number of lines that are shown before halting the
displayed data (decimal value).
Epson Research and Development
Vancouver Design Center
13706PLAY Diagnostic Utility
Issue Date: 01/02/23
Advertisement
Chapters
Table of Contents
