Epson Research and Development
Vancouver Design Center
2.3 VCC - Horizontal Logic Power Supply
Connecting to the Epson D-TFD Panels
Issue Date: 01/02/23
The power supply for the horizontal logic circuitry must be set at 3.3V. The panel must be
ready for use before this supply is turned on. A general purpose output pin may be used to
control VCC (GPO on the S1D13706). Figure 2-4: "VCC Power Supply" shows an
example of this power supply. The control signal (GPO) in this implementation activates
VCC when it is low.
3.3V
GPO
Figure 2-4: VCC Power Supply
Q1
NDS9400A/SO
2
8
3
7
6
4
5
VCC = 3.3V
C1
10uF 16V
Page 11
S1D13706
X31B-G-012-03