Siemens Sinumerik 840D sl Diagnostic Manual page 656

Overview of Alarms
SINAMICS-Alarms
aa = 07 hex = 7 dec:
An NX10 or NX15 was not directly connected to a permitted Control Unit.
aa = 08 hex = 8 dec:
A component was connected to a Control Unit that is not permitted for this purpose.
aa = 0A hex = 10 dec:
Too many components of a certain type detected.
aa = 0B hex = 11 dec:
Too many components of a certain type detected at a single line.
Note:
The drive system is no longer booted. In this state, the drive control (closed-loop) cannot be enabled.
Remedy: Re fault cause = 1:
Change the configuration. Connect less than 199 components to the Control Unit.
Re fault cause = 2:
Remove the component with unknown component type.
Re fault cause = 3, 4, 5:
Establish a valid combination.
Re fault cause = 6, 7:
Connect the expansion module directly to a permitted Control Unit.
Re fault cause = 8:
Remove component.
Re fault cause = 10, 11:
Reduce the number of components.
201361 <location>Topology: Actual topology contains SINUMERIK and
SIMOTION components
Message %1
value:
Drive object: All objects
Reaction: NONE
Acknowledge: NONE
Cause: The detected actual topology contains SINUMERIK and SIMOTION components.
The drive system is no longer booted. In this state, the drive control (closed-loop) cannot be enabled.
Fault value (r0949, interpret hexadecimal):
ddccbbaa hex: cc = fault cause, bb = component class of the actual topology, aa = component number
of the component
cc = 01 hex = 1 dec:
An NX10 or NX15 was connected to a SIMOTION control.
cc = 02 hex = 2 dec:
A CX32 was connected to a SINUMERIK control.
Remedy: Re fault cause = 1:
Replace all NX10 or NX15 by a CX32.
Re fault cause = 2:
Replace all CX32 by an NX10 or NX15.
201375 <location>Topology: Actual topology, duplicate connection between two
components
Message Preliminary component number: %1, component class: %2, connection number: %3
value:
Drive object: All objects
Reaction: NONE
Acknowledge: IMMEDIATELY
Cause: When detecting the actual topology, a ring-type connection was detected.
Fault value (r0949, interpret hexadecimal):
ccbbaaaa hex:
cc = connection number
bb = component class
aaaa = preliminary component number of a component included in the ring
2-656
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
© Siemens AG 2009 All Rights Reserved
03/2009