Siemens Sinumerik 840D sl Diagnostic Manual page 493

03/2009
Definitions: The parking position is below retraction plane XRA.
Alarm triggered by following cycle: F_SP_RP.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Move the parking position above retraction plane XRA.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61286 [Channel %1: ] Block %2: machining not possible, check tool angle.
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Machining not possible with the specified tool.
Alarm triggered by following cycles: F_UCUT_T.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Use a suitable tool.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61287 [Channel %1: ] Block %2: no master spindle active.
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: No master spindle active.
Alarm triggered by following cycle: CYCLE63, CYCLE64, F_TFS.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Activate the master spindle (machine data 20090).
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61288 [Channel %1: ] Block %2: Main spindle not set up
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: F_SP_INI
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Enter channel axis number of main spindle in MD52206 $MCS_AXIS_USAGE.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61289 [Channel %1: ] Block %2: Counterspindle not set up
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: F_SP_INI
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Enter channel axis number of counterspindle in MD52206 $MCS_AXIS_USAGE.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
© Siemens AG, 2009. All Rights Reserved
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
Overview of Alarms
NCK alarms
2-493