Siemens Sinumerik 840D sl Diagnostic Manual page 207

03/2009
14530 [Channel %1: ] Block %2 EXTERN and PROC instruction do not
correspond
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Subroutines with parameter transfer must be known before they are called in the program. If the sub-
routines are always available (fixed cycles) the control establishes the call interfaces at the time of
system power-up. Otherwise an EXTERN statement must be programmed in the calling program.
Example:
N123 EXTERN UPNAME (TYP1, TYP2, TYP3, ...)
The type of the variable must match the type given in the definition (PROC statements) or it must be
compatible with it. The name can be different.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Check the variable types in the EXTERN and the PROC statements for correspondence and correct-
ness.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
14540 [Channel %1: ] Block %2 contour tool: the min. limit angle has been
programmed more than once (edge D%3)
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Edge number, label
Definitions: The limit angle of a contour tool must be equal zero in an involved edge only.
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy: Change tool definition.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14541 [Channel %1: ] Block %2 contour tool: the max. limit angle has been
programmed more than once (edge D%3)
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Edge number, label
Definitions: The limit angle of a contour tool must be equal zero in an involved edge only.
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy: Change tool definition.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14542 [Channel %1: ] Block %2 contour tool: the min. limit angle has not been
programmed
Parameters: %1 = Channel number
%2 = Block number, label
© Siemens AG, 2009. All Rights Reserved
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
Overview of Alarms
NCK alarms
2-207