Siemens Sinumerik 840D sl Diagnostic Manual page 135

03/2009
12080 [Channel %1: ] Block %2 syntax error in text %3
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Source text area
Definitions: At the text position shown, the grammar in the block is incorrect. The precise reason for this error can-
not be specified in more detail because there are too many possibilities.
Example 1:
N10 IF GOTOF ... ; the condition for the jump is missing!
Example 2:
N10 DEF INT VARI=5
N11 X VARI ; the operation is missing for the X and VARI variables
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Press the NC Stop key and select the function "Correction block" with the softkey PROGRAM COR-
RECT. The correction pointer positions on the incorrect block.
Analyze the block and correct it in accordance with the syntax rules given in the Programming Guide.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
12090 [Channel %1: ] Block %2 unexpected parameter %3
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Disallowed parameters in the text
Definitions: The programmed function has been predefined; no parameters are allowed in its call. The first unex-
pected parameter is displayed.
Example: On calling the predefined subroutine TRAFOF (switching off a transformation) parameters
have been transferred (one or more).
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Press the NC Stop key and select the function "Correction block" with the softkey PROGRAM COR-
RECT. The correction pointer positions on the incorrect block.
Program function without parameter transfer.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
12100 [Channel %1: ] Block %2 number of passes %3 not permissible
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Number of passes
Definitions: The subroutines called with MCALL are modal, i.e. after each block with positional information a rou-
tine run is automatically performed once. For this reason, programming of the number of passes under
address P is not allowed.
The modal call is effective until another MCALL is programmed, either with a new subroutine name or
without (delete function).
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Press the NC Stop key and select the function "Correction block" with the softkey PROGRAM COR-
RECT. The correction pointer positions on the incorrect block.
Program the subroutine call MCALL without number of passes.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
12110 [Channel %1: ] Block %2 block syntax cannot be interpreted
Parameters: %1 = Channel number
%2 = Block number, label
© Siemens AG, 2009. All Rights Reserved
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
Overview of Alarms
NCK alarms
2-135