Siemens Sinumerik 840D sl Diagnostic Manual page 125

03/2009
10916 [Channel %1: ] Block %2 preparation problem in Look Ahead (module
%3, identifier %4)
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Module identifier
%4 = Error code
Definitions: The parameterized memory is inadequate to create an optimum path velocity profile. The profile cre-
ated is not as smooth as it could be.
Reaction: Local alarm reaction.
Alarm display.
Warning display.
Remedy: Change parameterization, increase IPO buffer.
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
10930 [Channel %1: ] Block %2 interpolation type not allowed in stock removal
contour
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The following types of interpolation are allowed in the contour program for stock removal: G00, G01,
G02, G03, CIP, CT
Reaction: Local alarm reaction.
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: In the contour subroutine, program only path elements that consist of straight lines and arcs.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
10931 [Channel %1: ] Block %2 incorrect stock removal contour
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The following errors occurred in the subroutine for the contour during stock removal:
- Full circle
- Overlapping contour elements
- Wrong start position
Reaction: Local alarm reaction.
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: The errors listed above must be corrected in the subroutine for the stock removal contour.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
10932 [Channel %1: ] Block %2 preparation of contour has been restarted
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The first contour preparation/contour decoding run must be terminated with EXECUTE.
Reaction: Local alarm reaction.
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Program the keyword EXECUTE to terminate the contour preparation in the part program before again
calling up contour segmentation (keyword CONTPRON).
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
© Siemens AG, 2009. All Rights Reserved
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
Overview of Alarms
NCK alarms
2-125