Siemens Sinumerik 840D sl Diagnostic Manual page 478

Overview of Alarms
NCK alarms
61218 [Channel %1: ] Block %2: Feed/tooth programmed, but number of tools
equals zero
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: For feed per tooth, the number of teeth has to be specified.
Alarm triggered by following cycles: E_TFS, E_DR_BGF, F_TFS.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Enter the number of teeth on the milling tool in the "Tool list" menu.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61219 [Channel %1: ] Block %2: Tool radius too large
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The tool radius is too large for machining.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Select a suitable tool.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61220 [Channel %1: ] Block %2: Tool radius too small
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The tool radius is too small for machining.
Alarm triggered by following cycles: CYCLE78.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Select a suitable tool.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61221 [Channel %1: ] Block %2: No tool active
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: No tool active.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Select a suitable tool.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61222 [Channel %1: ] Block %2: Plane infeed greater than tool diameter
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The plane infeed must not be greater than the tool diameter.
Alarm triggered by following cycles: CYCLE79, , E_MI_PL, E_PO_CIR, E_PO_REC, F_PO_CIR,
F_PO_REC.
2-478
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
© Siemens AG, 2009. All Rights Reserved
03/2009