Siemens Sinumerik 840D sl Diagnostic Manual page 164

Overview of Alarms
NCK alarms
12701 [Channel %1: ] Block %2 illegal interpolation type for contour definition
active
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: In one contour definition block, G01 is not active as interpolation function. In one contour definition
block, the linear interpolation always has to be selected with G01. G00, G02, G03, G33 etc. are not
permitted.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program. Program linear interpolation G01.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
12710 [Channel %1: ] Block %2 illegal language element in external language
mode
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The programmed language element is not allowed or unknown in external language mode. Only the
language elements from Siemens mode which are used for subprogram calls (except for Lxx) and the
language constructs for program repetition with REPEAT (UNTIL) are allowed.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program.
Check that the language command is available in Siemens mode. Switch to Siemens mode with G290.
Program the command in the next block and switch back to the external language mode in the follow-
ing block.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
12720 [Channel %1: ] Block %2 program number for macro call (G65/G66)
missing
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: During macro call with G65/G66 no program number was defined. The program number must be pro-
grammed with address "P".
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
12722 [Channel %1: ] Block %2 multiple ISO_2/3 macro or cycle calls in the
block
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: A mixture of cycle and macro calls are programmed in a block, e.g. cycle calls with G81 - G89 together
with an M macro in the block or a G65/G66 macro call together with M macros in the block.
G05, G08, G22, G23, G27, G28, G29, G30, G50.1, G51.1, G72.1, G72.2 functions (ISO mode) also
execute subroutine calls. Only one macro or cycle call can appear in an NC block.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Deactivate modal cycles or modal macro calls if one of the above mentioned G functions has been
programmed.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
2-164
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
© Siemens AG, 2009. All Rights Reserved
03/2009