Siemens Sinumerik 840D sl Diagnostic Manual page 116

Overview of Alarms
NCK alarms
Definitions: No intermediate point was found when programming a contour consisting of two straight lines and an
angle specification.
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy: Modify part program.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
10792 [Channel %1: ] Block %2 illegal interpolation type during linear
programming with angles
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Only spline or linear interpolation is permitted for programming two straight lines with angle specifica-
tion. Circular or polynomial interpolation is not allowed.
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy: Modify part program.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
10793 [Channel %1: ] Block %2 second block missing during linear
programming with angles
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The second block is missing during programming of two straight lines with angle specification. This
situation only occurs if the first subblock is also the last block of a program, or if the first subblock is
followed by a block with a preprocessor stop.
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy: Modify part program.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
10794 [Channel %1: ] Block %2 angle specification missing in 2nd block during
linear interpolation with angles
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The angle is missing from the second block during programming of two straight lines with angle spec-
ification. This error can only occur if an angle was programmed in the preceding block, but no axis of
the active plane was programmed in that block. The cause of the error may therefore also have been
the intention to program a single straight line with an angle in the previous block. In this case, exactly
one axis of the active plane must be programmed.
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy: Modify part program.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
2-116
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
© Siemens AG, 2009. All Rights Reserved
03/2009