Siemens Sinumerik 840D sl Diagnostic Manual page 464

Overview of Alarms
NCK alarms
Definitions: The nominal or core diameter was incorrectly programmed. Alarm triggered by following cycles:
CYCLE70, E_MI_TR, F_MI_TR.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Check thread geometry.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61120 [Channel %1: ] Block %2: Thread type inside / outside not defined
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The thread type (internal/external) was not defined. Alarm triggered by following cycles: CYCLE70.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: The internal/external thread type must be entered.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61121 [Channel %1: ] Block %2: Number of teeth per cutting edge is missing
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: No value was entered for the number of teeth per cutting edge. Alarm triggered by following cycles:
CYCLE70.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Enter the number of teeth/cutting edges for the active tool into the tool list.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61122 [Channel %1: ] Block %2: Safety distance incorrectly defined in plane
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The safety clearance is negative or zero. This is not allowed.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Define the safety clearance.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61123 [Channel %1: ] Block %2: CYCLE72 cannot be simulated
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE72.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
2-464
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
© Siemens AG, 2009. All Rights Reserved
03/2009