Siemens Sinumerik 840D sl Diagnostic Manual page 234

Overview of Alarms
NCK alarms
15165 [Channel %1: ] Block %2 error when translating or interpreting Asup %3
Parameters: %1 = Channel number
%2 = Block number, label
%3 = String
Definitions: At part program start and at start of an ASUB under Reset condition, the relevant data of all the ASUBs
that can be activated at that time are processed:
- PLC ASUBs
- With MD20108 $MC_PROG_EVENT_MASK configured event-controlled program calls
- ASUB after block search (MD11450 $MN_SEARCH_RUN_MODE bit 1=1)
- Editable system ASUB ($MN_ASUP_EDITABLE)
If an error occurs (converter or interpreter), alarm 15165 will be output first and then a converter or
interpreter alarm that describes more details of the error. Alarm 15165 will cause an interpreter stop.
A compensation block will not be possible.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Modify part program.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
15166 [Channel %1: ] User system asup _N_ASUP_SPF not available
Parameters: %1 = Channel number
Definitions: By means of the MD11610 $MN_ASUP_EDITABLE the function "User-defined system asup" has
been activated. However, the relevant user program could not be found in the specified search path:
- 1. /_N_CUS_DIR/_N_ASUP_SPF
- 2. /_N_CMA_DIR/_N_ASUP_SPF
The default system asups are used.
Reaction: Interface signals are set.
Alarm display.
Remedy: Load the user-defined system asup in /_N_CUS_DIR/_N_ASUP_SPF or
/_N_CMA_DIR/_N_ASUP_SPF laden.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
15170 [Channel %1: ] Block %2 program %3 could not be compiled
Parameters: %1 = Channel number
%2 = Block number, label
%3 = String
Definitions: An error has occurred in compile mode. The (compiler) error message refers to the program specified
here.
Reaction: Alarm display.
Remedy: Modify part program.
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
15171 [Channel %1: ] Block %2 compiled program %3 older than the relevant
subroutine
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Compiled program file name
Definitions: When calling a precompiled subroutine, it was noticed that the compiled program is older than the rel-
evant SPF file. The compiled program was deleted and during start the subroutine is executed instead
of the compiled program.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Perform another precompilation.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
2-234
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
© Siemens AG, 2009. All Rights Reserved
03/2009