Siemens Sinumerik 840D sl Diagnostic Manual page 239

03/2009
15350 [Channel %1: ] Block %2 search target not found
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The specified program has been searched to the end of the program without the selected search tar-
get having been found.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Check the part program, change the block search (typing error in the part program) and restart the
search.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
15360 [Channel %1: ] Illegal target of block search (syntax error)
Parameters: %1 = Channel number
Definitions: The specified search target (block number, label or string) is not allowed in block search.
Reaction: Alarm display.
Remedy: Correct target of block search.
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
15370 [Channel %1: ] Target of block search not found
Parameters: %1 = Channel number
Definitions: In a block search, an impermissible search target has been specified (e.g. negative block number).
Reaction: Alarm display.
Remedy: Check the specified block number, label or character string. Repeat entry with correct search target.
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
15380 [Channel %1: ] Block %2 illegal incremental programming in axis %3
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis
Definitions: The first axis programming after "search to block end point" is performed incrementally. This is not
allowed in the following situations:
- After searching the target a transformation change has taken place.
- A frame with rotation component is active. The programmed axis is involved in the rotation.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Find search destination in which the axes are programmed using an absolute reference.
Deactivate adding of the accumulated search position with SD42444
$SC_TARGET_BLOCK_INCR_PROG = FALSE.
Use search run with calculation "at contour".
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
15390 [Channel %1: ] Block %2 %3 not executed during block search
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Source symbol
Definitions: During block search, commands for switching, deleting and defining of the electronic gear are not exe-
cuted and not gathered but simply skipped.
Reaction: NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Set the desired gear status via asynchronous subprogram.
© Siemens AG, 2009. All Rights Reserved
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
Overview of Alarms
NCK alarms
2-239