Siemens Sinumerik 840D sl Diagnostic Manual page 525

03/2009
61738 [Channel %1: ] Block %2: Incorrect cutting edge position
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE952
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: - Check cutting edge position in tool management
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61739 [Channel %1: ] Block %2: Blank must be closed contour
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE952
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: - Check whether the blank contour is closed
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61740 [Channel %1: ] Block %2: Collision through approach
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE952
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: - Select the starting position to enable collision-free approach of the contour
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61741 [Channel %1: ] Block %2: Axis in negative range
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE952
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: - Check the position of the axis in the ordinate
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61742 [Channel %1: ] Block %2: Retraction plane %4 is within the machining
range
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE952
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: - On internal machining check machining range in relation to the entered
retraction distance ($SCS_TURN_ROUGH_I_RELEASE_DIST)
© Siemens AG, 2009. All Rights Reserved
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
Overview of Alarms
NCK alarms
2-525