Siemens Sinumerik 840D sl Diagnostic Manual page 119

03/2009
Remedy: Program feedrate in accordance with the interpolation type.
- G93: The feedrate is specified as a time-reciprocal value under address F in [rev/min].
- G94 and G97: The feedrate is programmed under address F in [mm/min] or [m/min].
- G95: The feedrate is programmed as revolutional feedrate under address F in [mm/revolution]
or under the address FZ in [mm/tooth].
- G96: The feedrate is programmed as cutting rate under address S in [m/min]. It is derived from the
current spindle speed.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
10861 [Channel %1: ] Block %3 velocity of positioning axis %2 is zero
Parameters: %1 = Channel number
%2 = Axis
%3 = Block number, label
Definitions: No axis velocity has been programmed and the positioning velocity set in the machine data is zero.
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
Remedy: Please inform the authorized personnel/service department. Enter a different velocity in MD32060
$MA_POS_AX_VELO.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
10862 [Channel %1: ] Block %2 master spindle also used as path axis
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: A contour has been programmed that also includes the master spindle as contouring axis. However,
the velocity of the contour is derived from the rotational speed of the master spindle (e.g. G95).
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
Remedy: Modify the program so that no reference is possible to the program itself.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
10865 [Channel %1 ] Block %2 FZ active, but no tool offset, tool %3
Parameters: %1 = Channel number
%2 = Axis name, spindle number
%3 = Tool
Definitions: For the displayed traversing block a tooth feedrate is active, but no tool offset.
Traversing can be performed after the error has been acknowledged. For calculation of the effective
feedrate one tooth per revolution will be assumed.
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy: Check the NC program for correct tool selection and correct it, if required; then continue the program
with NC start.
Or:
Continue the NC program with NC start. For calculation of the effective feedrate one tooth per revolu-
tion is assumed.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
© Siemens AG, 2009. All Rights Reserved
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
Overview of Alarms
NCK alarms
2-119