Siemens Sinumerik 840D sl Diagnostic Manual page 285

03/2009
Note:
The alarm can only be generated if the simulation has been completed during the search run. The
alarm cannot be output immediately at the start of the search run.
Reaction: NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: MD11410 $MN_SUPPRESS_ALARM_MASK, MD22680 $MC_AUTO_IPTR_LOCK and language
command IPTRLOCK
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
16952 [Channel %1: ] Start program command not possible due to MDI
Parameters: %1 = Channel ID
Definitions: NCK is currently executing an ASUB in MDI mode. In this constellation, parts program command
"Start" is not allowed for another channel. Attention: If an asup is started from JOG, the NCK can inter-
nally change to MDI, if the NCK was previously in MDI and not in RESET. Note: Without this alarm,
the MDI buffer of the other channel would always be started.
Reaction: NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Start ASUB in AUTO or ->JOG in AUTO
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
16953 [Channel %1: ] For slave axis %2 SERUPRO not allowed, as master axis
%3 not subject to axis/spindle disable
Parameters: %1 = Channel number
%2 = Slave axis name, following spindle number
%3 = Master axis name, master spindle number
Definitions: Currently, the alarm occurs only in combination with the SERUPRO action. SERUPRO stands for
search via program test.
SERUPRO is possible only with an active coupling, if the axis/spindle disable is active for all master
axes/spindles of the slave axis/spindle
Reaction: NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Set axis/spindle disable of the master axis
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
16954 [Channel %1: ] Block %2 programmed stop prohibited in stop delay area
Parameters: %1 = Channel ID
%2 = Block number, label
Definitions: In a program area (stop delay area) that is bracketed with DELAYFSTON and DELAYFSTOF, a pro-
gram command was used that causes a stop. No commands other than G4 are permissible that might
cause a stop even though only shortly. A stop delay area can also be defined by MD11550
$MN_STOP_MODE_MASK.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: MD11550 $MN_STOP_MODE_MASK and language command DELAYFSTON DELAYFSTOF
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
© Siemens AG, 2009. All Rights Reserved
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
Overview of Alarms
NCK alarms
2-285