Siemens Sinumerik 840D sl Diagnostic Manual page 91

03/2009
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
10635 [Channel %1: ] Axis %2, tool radius compensation is inactive for type %3
working area limitation, reason: no milling or drilling tool.
Parameters: %1 = Channel number
%2 = Axis, spindle
%3 = 0: BCS, 1: WCS / SZS
Definitions: The tool radius compensation of the working area limitation of the stated axis is not taken into account.
Reason: The tool must be of type milling cutter or drill.
The alarm is reported in JOG mode.
Reaction: Alarm display.
Remedy: The tool radius compensation for working area limitations in JOG mode can only be taken into account
for milling or drilling tools.
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
10636 [Channel %1: ] Axis %2, tool radius compensation is inactive for type %3
working area limitation, reason: Transformation is active.
Parameters: %1 = Channel number
%2 = Axis, spindle
%3 = 0: BCS, 1: WCS / SZS
Definitions: The tool radius compensation of the working area limitation of the stated axis is not taken into account.
Reason: A transformation is active.
The alarm is reported in JOG mode.
Reaction: Alarm display.
Remedy: The tool radius compensation for working area limitations in JOG mode cannot be taken into account
if transfomation is active.
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
10637 [Channel %1: ] Axis %2, tool radius compensation is inactive for type %3
working area limitation, reason: Tool not active.
Parameters: %1 = Channel number
%2 = Axis, spindle
%3 = 0: BCS, 1: WCS / SZS
Definitions: The tool radius compensation of the working area limitation of the stated axis is not taken into account.
Reason: No tool is active.
The alarm is reported in JOG mode.
Reaction: Alarm display.
Remedy: The tool radius compensation for working area limitations in JOG mode cannot be taken into account
wihout an active tool.
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
10650 [Channel %1: ] Axis %2 incorrect gantry machine data, error code %3
Parameters: %1 = Channel number
%2 = Axis
%3 = Error no.
Definitions: An incorrect value was entered in the gantry-specific axial machine data. Further information can be
derived from the error number.
- Error no. = 1 => either an incorrect gantry unit has been entered or the designation of the following
axis is incorrect.
- Error no. = 2 => master axis has been specified more than once.
Reaction: NC not ready.
Mode group not ready, also effective for single axes
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
© Siemens AG, 2009. All Rights Reserved
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
Overview of Alarms
NCK alarms
2-91