Siemens Sinumerik 840D sl Diagnostic Manual page 613

03/2009
113030 PLC connection '%1' not in 'common.com'
Parameters: %1 = --
Definitions: --
Remedy: --
113031 PLC interpreter: %1 bytes not allocated
Parameters: %1 = --
Definitions: --
Remedy: --
113032 Invalid PLC command: %1
Parameters: %1 = --
Definitions: --
Remedy: --
113033 Block cannot be recompiled
Definitions: --
Remedy: --
113034 No softkey is allowed in this state - ignored
Definitions: --
Remedy: --
113100 Internal error %1
Parameters: %1 = --
Definitions: --
Remedy: --
120000 Area %1 cannot be loaded! Acknowledge alarm, press area switchover
key!
Parameters: %1 = Operating area name
Definitions: One of the applications listed in the REGIE.INI could not be started.
Reaction: Alarm display.
Remedy: Check whether the entry in REGIE.INI is correct.
Program Con- Internal
tinuation:
120001 Area %1 cannot be selected. Please deactivate area %2
Parameters: %1 = Operating area name
%2 = Operating area name
Definitions: Within the scope of an area switchover, a different area is to be terminated (unloaded).
However, the area refuses this.
The area switchover does not take place.
Reaction: Alarm display.
Remedy: Try again and, if possible, first close the area that could not be deactivated.
Program Con- Internal
tinuation:
120002 Area %1 is still active. Please deactivate area %1
Parameters: %1 = Operating area name
Definitions: When the MMC system is closed (closing the master control), an area is to be terminated.
However, the area refuses this.
The system was NOT closed.
Reaction: Alarm display.
Remedy: Try again and, if possible, first close the area that could not be deactivated.
Program Con- Internal
tinuation:
© Siemens AG 2009 All Rights Reserved
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
Overview of Alarms
HMI-Alarms
2-613