Siemens Sinumerik 840D sl Diagnostic Manual page 204

Overview of Alarms
NCK alarms
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14412 [Channel %1: ] Block %2 transformation active at geometry axis
changeover
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: It is not permissible to change the assignment of geometry axes to channel axes when transformation
is active.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14413 [Channel %1: ] Block %2 fine tool correction: changeover
geometry/channel axis not allowed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: It is not permissible to change the assignment of geometry axes to channel axes during active tool fine
compensation.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14414 [Channel %1: ] Block %2 GEOAX function: incorrect call
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The parameters for calling the GEOAX(...) are incorrect. Possible causes:
- Uneven number of parameters.
- More than 6 parameters were specified.
- A geometry axis number was programmed which was less than 0 or greater than 3.
- A geometry axis number was programmed more than once.
- An axis identifier was programmed more than once.
- An attempt was made to assign a channel axis to a geometry axis which has the same name as one
of the channel axes.
- An attempt was made to assign a channel axis to a geometry axis lacking IPO functionality (see
MD30460 $MA_BASE_FUNCTION_MASK, Bit8).
- An attempt was made to remove a geometry axis with the same name as one of the channel axes
from the geometry axis grouping.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program or correction block.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14415 [Channel %1: ] Block %2 tangent control: changeover geometry/channel
axis not allowed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: An assignment change of the geometry axes to channel axes is not permitted with active tangential
control.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
2-204
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
© Siemens AG, 2009. All Rights Reserved
03/2009