Siemens Sinumerik 840D sl Diagnostic Manual page 297

03/2009
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
17192 [TO unit %1: ] Invalid tool designation of '%2', duplo no. %3. No more
replacement tools possible in '%4'.
Parameters: %1 = TO unit
%2 = Tool identifier
%3 = Duplonummer
%4 = Group identifier
Definitions: The tool with the specified tool identifier, duplo number cannot accept the group identifier. Reason:
The maximum number of replacement tools allowed has already been defined. The name allocation
causes the tool to be reallocated to a tool group which already contains the maximum number of
replacement tools allowed on this machine.
Reaction: Interface signals are set.
Alarm display.
Remedy: Use fewer replacement tools or request a different maximum setting from the machine manufacturer.
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
17193 [Channel %1: ] Block %2 the active tool is no longer on toolholder
no./spindle no. %3, program %4
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Toolholder no., spindle no.
%4 = Program name
Definitions: The tool at the specified toolholder/spindle at which the last tool change was carried out as master
toolholder or master spindle, has been replaced.
Example:
N10 SETHTH(1)
N20 T="Wz1" ; Tool change at master toolholder 1
N30 SETMTH(2)
N40 T1="Wz2" ; Toolholder 1 is only a secondary toolholder.
Changing the tool does not result in correction deselection.
N50 D5; New correction selection. At present, there is no active tool which D can refer to, i.e. D5 refers
to T no. = 0, which results in zero correction.
Reaction: Interface signals are set.
Alarm display.
Remedy: - Modify program:
- Set desired spindle as master spindle or toolholder as master toolholder.
- Then, if required, reset master spindle or master toolholder.
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
17194 [Channel %1: ] Block %2 no suitable tool found
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: - An attempt was made to access a tool which has not been defined.
- The specified tool does not permit access.
- A tool with the desired properties is not available.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Check access to tool:
- Are the parameters of the command correctly programmed?
- Does the status of the tool prevent access?
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
© Siemens AG, 2009. All Rights Reserved
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
Overview of Alarms
NCK alarms
2-297