Siemens Sinumerik 840D sl Diagnostic Manual page 531
Hide thumbs
Also See for Sinumerik 840D sl:
- Function manual (2184 pages) ,
- Programming manual (1334 pages) ,
- Commissioning manual (1102 pages)
Table of Contents
Advertisement
03/2009
Remedy:
- Check whether the labels exist in the island contour
Program Con-
Clear alarm with the RESET key. Restart part program
tinuation:
61905
[Channel %1: ] Block %2: Label %4 not existing in the spigot contour
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
Alarm triggered by following cycles: CYCLE63
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
- Check whether the labels exist in the spigot contour
Program Con-
Clear alarm with the RESET key. Restart part program
tinuation:
61906
[Channel %1: ] Block %2: Label %4 not existing in the contour
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
Alarm triggered by following cycles: CYCLE64
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
- Check whether the labels exist in the contour
Program Con-
Clear alarm with the RESET key. Restart part program
tinuation:
61907
[Channel %1: ] Block %2: Pocket contour missing
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
Alarm triggered by following cycles: CYCLE63, CYCLE64
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
- Check contour call
Program Con-
Clear alarm with the RESET key. Restart part program
tinuation:
61908
[Channel %1: ] Block %2: Blank contour missing
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
Alarm triggered by following cycles: CYCLE63, CYCLE64
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
- Check contour call
Program Con-
Clear alarm with the RESET key. Restart part program
tinuation:
61909
[Channel %1: ] Block %2: Error in pocket contour %4
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
Alarm triggered by following cycles: CYCLE63
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
© Siemens AG, 2009. All Rights Reserved
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
Overview of Alarms
NCK alarms
2-531
Hide quick links:
Advertisement
Table of Contents
