Siemens Sinumerik 840D sl Diagnostic Manual page 498

Overview of Alarms
NCK alarms
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61322 [Channel %1: ] Block %2: Check 4th digit of _KNUM
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The stated digit of _KNUM includes invalid values. Also check _MVAR.
Alarm is triggered: CYCLE974, CYCLE977, CYCLE978, CYCLE979, CYCLE994, CYCLE998,
CYCLE114.
Remedy: Check parameter for tool offset target (_KNUM) and measurement variant (_MVAR)
61323 [Channel %1: ] Block %2: Check 5th digit of _KNUM
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The stated digit of _KNUM includes invalid values. Also check _MVAR.
Alarm is triggered: CYCLE974, CYCLE977, CYCLE978, CYCLE979, CYCLE994, CYCLE998,
CYCLE114.
Remedy: Check parameter for tool offset target (_KNUM) and measurement variant (_MVAR)
61324 [Channel %1: ] Block %2: Check 6th digit of _KNUM
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The stated digit of _KNUM includes invalid values. Also check _MVAR.
Alarm is triggered: CYCLE974, CYCLE977, CYCLE978, CYCLE979, CYCLE994, CYCLE998,
CYCLE114.
Remedy: Check parameter for tool offset target (_KNUM) and measurement variant (_MVAR)
61325 [Channel %1: ] Block %2: Check measuring axis/offset axis
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm is triggered by: all measuring cycles except CYCLE979
Remedy: For 840D:
- Check parameters for measuring axis _MA
For 840D sl:
- Check parameters for measuring axis (X, Y, Z)
61326 [Channel %1: ] Block %2: Check measuring direction
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered: CYCLE973, CYCLE976.
Remedy: Parameter for measuring direction _MD has an incorrect value.
61327 [Channel %1: ] Block %2: Program reset required
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: NC reset required.
Alarm is triggered: all measuring cycles except for CYCLE973, CYCLE976.
Remedy: Execute NC reset.
61328 [Channel %1: ] Block %2: Check D number
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: D number in parameter _KNUM is 0.
The alarm can be triggered by all measuring cycles.
Remedy: Check parameter for tool offset target (_KNUM)
61329 [Channel %1: ] Block %2: Check rotary axis
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered: CYCLE998
2-498
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
© Siemens AG, 2009. All Rights Reserved
03/2009