Siemens Sinumerik 840D sl Diagnostic Manual page 247

03/2009
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
16105 [Channel %1: ] Block %2 spindle %3 cannot be assigned
Parameters: %1 = Channel number
%2 = Block number, label
%3 = String
Definitions: Mistake in programming: The programmed spindle is not assigned a real spindle by the spindle num-
ber converter. The alarm can be issued after improper use of SD42800 $SC_SPIND_ASSIGN_TAB[].
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Correct setting data or modify part program.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
16110 [Channel %1: ] Block %2 spindle %3 for dwell time not in control mode
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis, spindle
Definitions: The spindle can be in the positioning mode, oscillating mode and control mode. With the M command
M70 it can be changed from a spindle to an axis. The control mode is divided into the speed-controlled
and position-controlled mode, and it is possible to alternate between these with the keywords SPCON
and SPCOF.
Positioning mode:
Position control (spindle position under SPOS/SPOSA)
Oscillating mode:
Speed control (M41 - M45 or M40 and S...)
Control mode:
Speed control (spindle speed under S..., M3/M4/M5)
Position control (SPCON/SPCOF, spindle speed under S..., M3/M4/M5)
Axis mode:
Position control (M70/M3, M4, M5, axis position under user-selectable axis name)
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Check part program for correct spindle number.
With M3, M4 or M5 put the required spindle into control mode before calling the dwell time.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
16111 [Channel %1: ] Block %2 spindle %3 No speed programmed
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Spindle
Definitions: Programming of a speed is expected.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Program speed with S[spindle number]=..
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
16112 [Channel %1: ] Block %2 following spindle %3 Impermissible
programming
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Spindle
© Siemens AG, 2009. All Rights Reserved
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
Overview of Alarms
NCK alarms
2-247