Siemens Sinumerik 840D sl Diagnostic Manual page 201

03/2009
14300 [Channel %1: ] Block %2 overlaid handwheel motion activated incorrectly
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Handwheel override has been called up incorrectly:
- 1st For positioning axes:
- Handwheel override programmed for indexing axes,
- No position programmed,
- FA and FDA programmed for the same axis in the block.
- 2nd For contouring axes:
- No position programmed,
- G60 not active,
- 1st G group incorrect (only G01 to CIP).
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14320 [Channel %3: ] Axis %4: handwheel %1 used twice (%2)
Parameters: %1 = Handwheel number
%2 = Use
%3 = Channel
%4 = Axis
Definitions: Informational alarm indicating that the mentioned handwheel is used twice:
The second parameter provides the explanation:
1: Block with axial handwheel override for this axis cannot be executed as the handwheel
for this axis performs a DRF movement
2: Block with velocity override of the path cannot be executed as the handwheel performs
a DRF movement for this axis of the path
3: Block with contour handwheel cannot be executed as the handwheel performs a DRF movement
for this axis of the path
4: PLC axis with axial handwheel override cannot be started immediately as the handwheel performs
a DRF movement for this axis
5: The axis is a reciprocating axis with axial handwheel override; the reciprocating movement cannot
be
started immediately as the handwheel performs a DRF movement for this axis
6: The DRF movement for this axis cannot be executed as an axial handwheel override is active for
this axis with the handwheel
7: The DRF movement for this axis cannot be executed as a velocity override of the path with
the handwheel is active and the axis belongs to the path
8: The DRF movement for this axis cannot be executed as the contour handwheel is active with
this handwheel and the axis belongs to the path
9: The DRF movement for this axis cannot be executed as the axis is a PLC axis with handwheel
override that is active with this handwheel
10: The DRF movement for this axis cannot be executed as the axis is active as reciprocating axis
with handwheel override with this handwheel
Reaction: Alarm display.
Remedy: Use the handwheel for one purpose at a time only.
Program Con- Alarm display showing cause of alarm disappears. No further operator action necessary.
tinuation:
© Siemens AG, 2009. All Rights Reserved
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
Overview of Alarms
NCK alarms
2-201