Siemens Sinumerik 840D sl Diagnostic Manual page 324

Overview of Alarms
NCK alarms
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
20061 [Channel %1: ] Axis %2 cannot be traversed as orientation axis
Parameters: %1 = Channel number
%2 = Axis name
Definitions: The axis is not an orientation axis and can therefore not be traversed as an orientation axis in JOG
mode.
Reaction: Alarm display.
Remedy: Register the axis as an orientation axis.
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
20062 [Channel %1: ] Axis %2 already active
Parameters: %1 = Channel number
%2 = Axis name, spindle number
Definitions: The displayed axis is already traversing as a machine axis. Therefore, it cannot be operated as a
geometry axis.
Traversing an axis can take place in JOG mode through 2 different interfaces.
1. As a geometry axis: via the channel-specific interface DB21-30 DBX12.6 / 12.7 (Traversing keys -
/+)
2. As a machine axis: via the axis-specific interface DB31, ... DBX4.7 / 4.6 (Traversing keys
plus/minus)
With the standard machine control panel, it is not possible to operate an axis as a machine axis and
as a geometry axis at the same time.
Reaction: Alarm display.
Remedy: Do not start the geometry axis until the traversing motion as machine axis has been concluded.
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
20063 [Channel %1: ] Axis %2 orientation axes cannot be traversed without
transformation
Parameters: %1 = Channel number
%2 = Axis name
Definitions: An attempt was made to move an orientation axis in JOG mode without an active orientation transfor-
mation.
Reaction: Alarm display.
Remedy: Activate an orientation transformation.
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
20064 [Channel %1: ] Axis %2 selection of several axes with an active taper
angle is not permitted.
Parameters: %1 = Channel number
%2 = Axis name, spindle number
Definitions: With an active taper angle, only one geometry axis at the time can be traversed in JOG mode by press-
ing traversing keys. Simultaneous traversing of a geometry axis as a machine axis is not permitted
either.
Reaction: Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Starting the geometry axis only if traversing of the other geometry axis or machine axis completed.
Program Con- Clear alarm with the RESET key in all channels. Restart part program.
tinuation:
2-324
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
© Siemens AG, 2009. All Rights Reserved
03/2009