Siemens Sinumerik 840D sl Diagnostic Manual page 258

Overview of Alarms
NCK alarms
16692 [Channel %1: ] Block %2 following axis/spindle %3 maximum number of
couplings in the block %4 has been exceeded
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
%4 = Maximum number of couplings
Definitions: The maximum number of generic couplings in the block has been exceeded.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program.
Reduce the number of generic couplings programmed in the block.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
16694 [Channel %1: ] Block %2 following axis/spindle %3 status/instruction %4
is not possible.
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
%4 = Status, instruction
Definitions: The stated instruction is not permitted for the current status of the generic coupling.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
16695 [Channel %1: ] Block %2 following axis/spindle %3 status/instruction %4
is not possible.
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
%4 = Status, instruction
Definitions: The stated instruction is not permitted for the current status of the generic coupling.
Reaction: NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Modify part program.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
16696 [Channel %1: ] Block %2 following axis/spindle %3 coupling has not
been defined.
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
Definitions: An instruction to an undefined coupling is to be executed.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part programm.
Define the coupling and activate, if necessary, before the instruction.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
2-258
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
© Siemens AG, 2009. All Rights Reserved
03/2009