Siemens Sinumerik 840D sl Diagnostic Manual page 544

Overview of Alarms
NCK alarms
62312 [Channel %1: ] Block %2: probe is not perpendicular to plane!
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions:
Reaction: Alarm display.
Remedy: --
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
62313 [Channel %1: ] Block %2: The number of lines per page _PROTFORM[0]
is incorrect and is automatically adjusted.
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: Alarm triggered by following cycle: CYCLE106.
Remedy: Check _PROTFORM[0] in the program.
62314 [Channel %1: ] Block %2: Traverse path limitation via software end
position, collision detection activated, continue with NC START / cancel
with RESET.
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm is triggered by the following cycle: CYCLE977
Remedy: Position the workpiece to be measured further away from the software end positions.
62315 [Channel %1: ] Block %2: Overwrite swivel data record TCARR = %4, yes
-> NC start, no -> reset
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm is triggered by the following cycle: CYCLE996
Remedy:
62316 [Channel %1: ] Block %2: Overwrite TRAORIdata, yes -> NC start, no ->
reset
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm is triggered by the following cycle: CYCLE996
Remedy:
62317 [Channel %1: ] Block %2: Tolerance of the linear vector %4 exceeded
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm is triggered by the following cycle: CYCLE996
Remedy:
62318 [Channel %1: ] Block %2: Tolerance of the rotary axis vector %4
exceeded
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm is triggered by the following cycle: CYCLE996
Remedy:
62335 [Channel %1: ] Block %2: No internal correction of the calibration data
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: Alarm triggered by the following cycles: CYCLE961, CYCLE977, CYCLE978, CYCLE979,
CYCLE996, CYCLE997, CYCLE998
2-544
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
© Siemens AG, 2009. All Rights Reserved
03/2009