Siemens Sinumerik 840D sl Diagnostic Manual page 524

Overview of Alarms
NCK alarms
61734 [Channel %1: ] Block %2: Machined part contour is outside the blank
contour
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE952
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: - Check programming of the machined part and blank contour, particularly their position towards each
other
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61735 [Channel %1: ] Block %2: Infeed D larger than the tip length of the tool
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE952
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: - Check infeed D in relation to the tip length of the tool in tool management
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61736 [Channel %1: ] Block %2: Machining cutting depth larger than maximum
depth of cut of the tool
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE952
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: --
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61737 [Channel %1: ] Block %2: Machining cutting depth smaller than minimum
depth of cut of the tool
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE952
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: --
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
2-524
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
© Siemens AG, 2009. All Rights Reserved
03/2009