Siemens Sinumerik 840D sl Diagnostic Manual page 237

03/2009
15186 [Channel %1: ] %2 errors in GUD, macro or INI file
Parameters: %1 = Channel number
%2 = Number of detected errors
Definitions: %2 errors were found when processing GUD/macro definition files (DEF files) or initialization files (INI
files)
Alarm 15180 has already informed about the corresponding file.
Prior to that the errors shown were reported by error-specific alarms, e.g. 12080 "syntax error".
Reaction: NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Modify definition file or initialization file
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
15187 [Channel %1: ] Error during execution of PROGEVENT file %3.
Parameters: %1 = Channel number
%2 = Is not used
%3 = PROGEVENT file name
Definitions: An error has occurred on executing PROGEVENT.
With alarm 15187, the name of the program that was started as PROGEVENT
is displayed. Alarm 15187 is displayed together
with the alarm that describes the error cause. Alarm 15187 is also output
when the alarm occurs in a subroutine started from PROGEVENT.
Reaction: Interface signals are set.
Alarm display.
Remedy: Correct the PROGEVENT file (subroutine).
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
15188 [Channel %1: ] Error during execution of ASUB file %3.
Parameters: %1 = Channel number
%2 = Is not used
%3 = ASUB file name
Definitions: An error has occurred on executing an ASUB.
Alarm 15188 displays the name of the program that was started
as ASUB. Alarm 15188 is output together with the alarm that
describes the error cause. Alarm 15188 is also output when
the alarm occurs in a subroutine started from the ASUB.
Reaction: Interface signals are set.
Alarm display.
Remedy: Correct the ASUB file (subroutine).
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
15190 [Channel %1: ] Block %2 not enough free memory for subroutine call
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The following deadlock has been found in the interpreter: Memory is needed for calling a subroutine.
The module memory is, however, empty and there is no prospect of module memory becoming free
again by executing the preprocessing/main run queue, because this queue is empty.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Please inform the authorized personnel/service department. Increase machine data MD28010
$MC_MM_NUM_REORG_LUD_MODULES / MD28040 $MC_MM_LUD_VALUES_MEM / MD18210
$MN_MM_USER_MEM_DYNAMIC or program a preprocessing stop STOPRE before calling the sub-
routine.
© Siemens AG, 2009. All Rights Reserved
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
Overview of Alarms
NCK alarms
2-237