Siemens Sinumerik 840D sl Diagnostic Manual page 497

03/2009
Definitions: Alarm is triggered: CYCLE971, CYCLE972, CYCLE982.
Remedy: Tool type impermissible for tool measurement/tool probe calibration.
61315 [Channel %1: ] Block %2: Check position of cutting edge
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm is triggered: CYCLE972, CYCLE973, CYCLE974, CYCLE982, CYCLE994.
Remedy: Check tool edge position (probe) in TO memory.
61316 [Channel %1: ] Block %2: Center and radius cannot be determined
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: No circle can be calculated from the measured points, as all measured points lie on a straight line.
The alarm is triggered by: CYCLE979
Remedy: Program change
61317 [Channel %1: ] Block %2: Check number of circle calculation points
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Parameterization faulty; requires 3 or 4 points to calculate the center point. Alarm is triggered:
CYCLE979.
Remedy: Change parameterization of CYCLE116.
61318 [Channel %1: ] Block %2: Check weighting factor
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm is triggered: CYCLE974, CYCLE977, CYCLE978, CYCLE979, CYCLE994, CYCLE998.
Remedy: Check parameter (_K).
61319 [Channel %1: ] Block %2: Check call parameter CYCLE114
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Internal error in measuring cycles. Alarm is triggered: CYCLE974, CYCLE977, CYCLE978,
CYCLE979, CYCLE994, CYCLE998.
Remedy: Check call parameter CYCLE114.
61320 [Channel %1: ] Block %2: Check tool number
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm can be triggered by following measuring cycles: all measuring cycles.
Remedy: For 840D:
- Check parameters _TNUM, _TNAME.
Bei 840D sl:
- Check parameter T.
With active tool management, parameter T=0 (_TNUM=0 ), and parameter _TNAME is empty or
the specified tool name is unknown to the tool management.
61321 [Channel %1: ] Block %2: Check WO memory number
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm is triggered: CYCLE974, CYCLE977, CYCLE978, CYCLE979, CYCLE994, CYCLE998.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: For 840D:
- Check parameter _KNUM
For 840D sl:
- Check the the number entered for the work offset compensation
© Siemens AG, 2009. All Rights Reserved
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
Overview of Alarms
NCK alarms
2-497