Siemens Sinumerik 840D sl Diagnostic Manual page 602

Overview of Alarms
HMI-Alarms
109013 Activation denied
Definitions: --
Remedy: --
110000 No data available for display
Definitions: --
Remedy: --
110001 Cannot read ACC variable:%1
Parameters: %1 = --
Definitions: --
Remedy: --
110002 No memory available
Definitions: --
Remedy: --
110003 COM file not found: %1
Parameters: %1 = --
Definitions: --
Remedy: --
110004 Screen not found: %1
Parameters: %1 = --
Definitions: --
Remedy: --
112045 Several approach points required
Definitions: Several insertion points are required for machining the contour pocket. The machining breaks up into
several individual machinings.
The program can be started.
This alarm is only a warning.
Residual material will remain.
Reaction: Alarm display.
Remedy: By using a smaller milling cutter, the machining could be done with an insertion point.
Program Con- Internal
tinuation:
112046 Main contour cannot be traced
Definitions: The pocket contour cannot be bypassed with the specified milling cutter.
Residual material will remain.
The program can be started.
This alarm is only a warning.
Reaction: Alarm display.
Remedy: By using a smaller milling cutter, the pocket contour could be bypassed.
Program Con- Internal
tinuation:
112052 No residual material available
Definitions: No residual material has been determined.
Reaction: Alarm display.
Remedy: Check parameters in the residual material cycle.
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
2-602
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
© Siemens AG 2009 All Rights Reserved
03/2009