Overview of Alarms
NCK alarms
Program Con-
Clear alarm with the RESET key. Restart part program
tinuation:
61900
[Channel %1: ] Block %2: Name of program to be generated is missing
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
Alarm triggered by following cycles: CYCLE63, CYCLE64
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
- Check parameter PRG
Program Con-
Clear alarm with the RESET key. Restart part program
tinuation:
61901
[Channel %1: ] Block %2: Contour %4 does not exist
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
Alarm triggered by following cycles: CYCLE63, CYCLE64
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
- Check contour call
- Check whether the contours exist in the program storage (workpieces, subroutines or part programs)
Program Con-
Clear alarm with the RESET key. Restart part program
tinuation:
61902
[Channel %1: ] Block %2: Label %4 not existing in the pocket contour
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
Alarm triggered by following cycles: CYCLE63
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
- Check whether the labels exist in the pocket contour
Program Con-
Clear alarm with the RESET key. Restart part program
tinuation:
61903
[Channel %1: ] Block %2: Label %4 not existing in the blank contour
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
Alarm triggered by following cycles: CYCLE63
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
- Check whether the labels exist in the blank contour
Program Con-
Clear alarm with the RESET key. Restart part program
tinuation:
61904
[Channel %1: ] Block %2: Label %4 not existing in the island contour
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
Alarm triggered by following cycles: CYCLE63
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
2-530
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
© Siemens AG, 2009. All Rights Reserved
03/2009