Siemens Sinumerik 840D sl Diagnostic Manual page 131

03/2009
Definitions: Compressor types COMPCURV and COMPCAD cannot be used in combination with tool radius com-
pensation. Only compressor type COMPON can be activated while tool radius compensation is active.
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy: Modify part program.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
10961 [Channel %1: ] Block %2 maximum cubic polynomials are allowed on
active radius compensation.
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: With active radius compensation, only up to cubic polynomials are permissible for the geometry axes.
In this case no 4th or 5th degree polynomials can be programmed.
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy: Modify part program.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
10962 [Channel %1: ] Block %2 function %3 not possible with path correction
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Funktionsname
Definitions: With this software release, the specified function can not yet be used together with tool radius com-
pensation. Please modifiy the part program or obtain a higher software version.
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy: Modify part program.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
10970 [Channel %1: ] Block %2 continuous-path mode active during punching
Parameters: %1 = Channel number
%2 = Block number
Definitions: The active continuous-path mode G64x is ignored during punching/nibbling.
Reaction: Alarm display.
Remedy: Disable continuous-path mode with G60 during punching/nibbling.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
10980 [Channel %1: ] Block %2 orientation smoothing not possible
Parameters: %1 = Channel number
%2 = Block number, label
© Siemens AG, 2009. All Rights Reserved
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
Overview of Alarms
NCK alarms
2-131