Siemens Sinumerik 840D sl Diagnostic Manual page 364

Overview of Alarms
NCK alarms
22290 [Channel %1: ] Spindle operation for transformed spindle/axis %2 not
possible (reason: error code %3).
Parameters: %1 = Channel number
%2 = Axis name, spindle number
%3 = Error code
Definitions: It is impermissible to start a spindle as long as it is being used by a transformation. Reason: spindle
usage in a transformation requires axis operation, which must not be exited.
This alarm may have the following reasons:
- Error code 1 : M3, M4 or M5 per synchronized action;
- Error code 2 : M41 through M45 per synchronized action;
- Error code 3 : SPOS, M19 per synchronized action;
- Error code 11 : DB31, ... DBX30.0 (Spindle stop);
- Error code 12 : DB31, ... DBX30.1 (Spindle start clockwise rotation);
- Error code 13 : DB31, ... DBX30.2 (Spindle start counterclockwise rotation;
- Error code 14 : DB31, ... DBX30.4 (Spindle positioning).
Reaction: NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Resolve the conflict, for example by deactivating transformation prior to spindle start.
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
22295 Channel %1 Spindle %2 DBB30 function not possible (cause: error code
%3)
Parameters: %1 = Channel number
%2 = Axis name, spindle number
%3 = Error code
Definitions: The function request by PLC via DBB30 interface could not be executed. The cause is specified by
the error code.
Error codes:
- Error code 1 : internal use
- Error code 2 : internal use
- Error code 3 : internal use
- Error code 4 : internal use
- Error code 5 : Switchover to command axis not possible
- Error code 6 : Switchover to PLC axis not possible
- Error code 20 : internal use
- Error code 21 : internal use
- Error code 22 : internal use
- Error code 23 : MD 30132 IS_VIRTUAL_AX has been set
- Error code 50 : internal use
- Error code 51 : internal use
- Error code 70 : internal use
Reaction: NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Remedy conflict.
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
2-364
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
© Siemens AG, 2009. All Rights Reserved
03/2009