Siemens Sinumerik 840D sl Diagnostic Manual page 194

Overview of Alarms
NCK alarms
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14165 [Channel %1: ] Block %2 selected ISO H/D number %3 does not match
tool %4
Parameters: %1 = Channel number
%2 = Block number, label
%3 = ISO H/D number
%4 = Tool number
Definitions: When an H or D number is programmed in ISO_2 or ISO_3 mode, it must be available in the active
tool. The active tool may also be the last tool loaded on the master spindle or master toolholder. This
alarm is output if there is no H or D number on this tool.
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy: Set ISO H/D number correctly.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14166 [Channel %1: ] Block %2 error %3 when programming a tool length offset
with TOFF / TOFFL
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Error code
Definitions: An error occurred while programming a tool length offset with TOFF or TOFFL. More information about
the type of error is given by the error code number:
Error code
1At least one tool length offset component has been programmed twice in one block (with TOFF).
2At least one tool length offset component has been programmed twice in one block (with TOFFL).
3Tool length offset components have been programmed in one block with both TOFF and TOFFL.
4An index must be declared when a tool length offset is programmed with TOFF, the form TOFF=....
is not permissible.
5An illegal index was declared when programming TOFFL (permissible values 1..3).
6An illegal axis was declared as the index when programming TOFF. Only geometry axes are permit-
ted.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Correct errors in program block.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14170 [Channel %1: ] Block %2 illegal interpolation type with tool length
compensation
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: If tool compensation (G43/G44) is activated in language mode ISO_M, the linear type of interpolation
must be active.
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy: Modify part program.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
2-194
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
© Siemens AG, 2009. All Rights Reserved
03/2009